Figure 50: Dv-Dosc Downfill Simulation (Circuiting Issues); Figure 51: Dv-Dosc Upfill Simulation - L-Acoustics dV-DOSC Operator's Manual

Figure 50: dV-DOSC downfill simulation (circuiting issues)

For dV-DOSC upfill simulation, an autofocus adjust angle of zero degrees corresponds to the first dV-
DOSC enclosure as parallel to the site angle of the top V-DOSC.
Note: To obtain the 0 degree relative angle, the 3.75 degree hole on dV-ANGLEP1 must be used during
installation.
For upfill purposes, the 5.5 or 7.5 degree holes can also be selected on dV-ANGLEP1. When using 5.5
or 7.5 degree holes, set autofocus adjust = 1.75 degrees or 3.75 degrees, respectively. This is
necessary to compensate for the 3.75 degree trapezoidal angle of the first dV-DOSC enclosure.

Figure 51: dV-DOSC upfill simulation

69
dV-DOSC dV-SUB Manual V3.0 June 2005