Table of Contents
Advertisement
Infinea X DF User Manual
Getting Started
Install Battery
1.
Verify the battery latch is fully open.
Note
Be careful to not force the battery into place, if the latch is closed and
locked.
2.
Lower the battery pack into place so it seats flat when installed.
3.
With slight pressure on the back of the battery, use your fingers
to rotate the latch counter-clockwise 90 degrees, or until it is
securely locked into place.
Assemble Infinea X DF
1.
Open the unit by loosening the six socket head hex screws, and
then gently flip open the top cover.
2.
On your iOS device, set the ring silent switch to Ring mode.
3.
Slide the iOS device onto the Lightning™ connector until it clicks
into place.
The Infinea X DF is molded specifically to the compatible iOS device. iOS
devices are not interchangeable
4.
Close the top cover while maintaining the position of the
protective rubber bumper.
Before closing the top cover, wipe the interior glass with a clean, lint-
free cloth to ensure the screen is clean and free from moisture.
5.
Tighten the six screws in the upper enclosure to secure it in this
order:
*
Top left
*
Bottom right
*
Top right
*
Bottom left
*
Center left
*
Center right
Between the top and bottom covers ensure the rubber bumper is
properly aligned. Failure to do so compromises the liquid protection
functionality of the unit.
9
Advertisement
Table of Contents
Need help?
Do you have a question about the Infinea X DF and is the answer not in the manual?