OZONE SOLUTIONS
Controls upper and lower conditions
for air pressure. System will start
when inlet air pressure exceeds
Start Up Set Point, and shut down
when below Shut Down Set Point.
Controls upper and lower conditions
for oxygen pressure. System will
start when oxygen pressure exceeds
Start Up Set Point, and shut down
when below Shut Down Set Point.
Controls upper and lower conditions
for ozone pressure. System will
start when ozone pressure exceeds
Start Up Set Point, and shut down
when below Shut Down Set Point.
Controls the length of time that the
system runs, with inverters off,
during shut down operation.
Important: Changing set points requires the user to be logged in as supervisor
12
/
WZ SERIES
Controls the length of time that the
system runs, with inverters off, when a
leak is detected.
Controls the maximum measurement
level acceptable in ambient
conditions. If measured levels exceed
this point, the system enters a leak
flushing cycle.
Controls upper and lower conditions
for dissolved ozone. System will start
when dissolved ozone is below ON set
point, and shut down when below OFF
Set Point.
Allows the system to automatically
control output based on readings
from the dissolved ozone monitor.
Allows the system to automatically
control flow through the system.
Displays active and
acknowledged alarms.
Acknowledges all alarms
displayed