Component Diagram; Components Description - Ozone Solutions Waterzone Series Installation & Operation Manual

OZONE SOLUTIONS
SECTION 2

COMPONENT DIAGRAM

20
21 22
23

COMPONENTS DESCRIPTION

1. Ozone Destruct Unit: Safely converts off-gassed
ozone into oxygen using a catalyst material. The
destruct unit uses a heater band to keep the
catalyst bed warm. This is to ensure no moisture
condensates on the catalyst. As long as the
Waterzone is connected to electrical power, this
canister should be warm (sometimes hot) to the
touch.
2. Emergency Stop Push Button: Allows you to easily
turn the system off quickly by pushing this switch.
3. HMI: This touch screen allows workers to control the
machine and view alarm conditions
6 / WZ SERIES
3
2
16
15
8
7
6
19
4. Air Vent: Safely removes all off-gassed ozone/
5. Ozone Injection Pump: This pump creates the
6. Injection Inlet Pressure Gauge: Indicates water
14
24
5
oxygen from the system. The gas flow from this vent
must be vented to a safe outdoor location or into an
ozone destruct unit.
pressure differential necessary across the venturi
injector for ozone injection. This pump should be
operating any time the Green Pump light on the
control panel is ON.
pressure on the inlet side of the venturi injector.
This pressure should be at least 20 PSI higher
than the injector outlet pressure gauge. Any time
the ozone injection pump is running this pressure
gauge should be higher than the injector outlet
pressure gauge.
4
9
8
17
10
18
12
13
11
1