Checking And Adjusting The Auger/Impeller Cable - Toro Power Max Heavy Duty 926 OXE Operator's Manual

3. Tighten the jam nut
1. Jam nut
Checking and Adjusting the
Auger/Impeller Cable
Service Interval: After the first 2 hours
Yearly
1. Remove the 2 screws from the right side of the belt
cover as shown.
2. Lift up the right side of the belt cover
3. With the auger/impeller lever disengaged, ensure that
the gap between the auger clutch assembly and the tab
is 1.5 mm (1/16 inch) as shown in
(Figure 43).
Figure 43
2. Turnbuckle
(Figure
Figure 44
Figure 45.
1. Tab
4. If the auger/impeller cable is not properly adjusted, do
the following steps:
5. Loosen the jam nut
44).
1. Jam nut
6. Loosen or tighten the turnbuckle that adjusts the
tension on the cable
7. Adjust the turnbuckle until you obtain the proper gap.
8. Tighten the jam nut.
9. Insert the 2 screws that you previously removed on
the belt cover.
10. If the auger/impeller cable is properly adjusted but
a problem remains, contact an Authorized Service
Dealer.
21
Figure 45
2. 1.5 mm (1/16 inch)
Figure 46.
Figure 46
2. Turnbuckle
(Figure 46).