Storage; Preparing The Machine For Storage; Removing The Machine From Storage - Toro Power Max Heavy Duty 926 OXE Operator's Manual

Figure 60
5. Turn the base of the bulb clockwise until it is snug
(Figure 61).
Figure 61
6. Insert the wire connector straight into the back of the
headlight until it is securely in place
Figure 62

Storage

• Fuel vapors can explode.
• Do not store fuel more than 30 days.
• Do not store the machine in an enclosure near
• Allow the engine to cool before storing it.
Preparing the Machine for
Storage
1. On the last refueling of the year, add fuel stabilizer to
2. Run the engine for 10 minutes to distribute the
(Figure 62).
3. Run the machine until the engine runs out of fuel.
4. Prime the engine and start it again.
5. Allow the engine to run until it shuts off. When you
6. Shut off the engine and allow it to cool.
7. Remove the ignition key.
8. Clean the machine thoroughly.
9. Touch up chipped surfaces with paint available from an
10. Tighten all loose screws, bolts, and locknuts. Repair or
11. Cover the machine and store it in a clean, dry place out
Removing the Machine from
Storage
Perform the annual maintenance procedures as given in the
Recommended Maintenance Schedule; refer to
25).
25
WARNING
an open flame.
fresh fuel.
Note: Fuel should not be stored longer than suggested
by the fuel-stabilizer manufacturer.
conditioned fuel through the fuel system.
can no longer start the engine, it is sufficiently dry.
Authorized Service Dealer. Sand affected areas before
painting, and use a rust preventative to prevent the
metal parts from rusting.
replace any damaged parts.
of the reach of children.
Storage (page