Table Of Contents - Toro Power Max Heavy Duty 926 OXE Operator's Manual

to obtain the proper High Altitude Kit and high-altitude
label for your machine. To locate a dealer convenient
to you, access our website at www.Toro.com or contact
our Toro Customer Care Department at the number(s)
listed in your Emission Control Warranty Statement.
Remove the kit from the engine and restore the engine
to its original factory configuration when running the
engine under 1500 m (5,000 ft). Do not operate an engine
that has been converted for high-altitude use at lower
altitudes; otherwise, you could overheat and damage the
engine. If you are unsure whether or not your machine
has been converted for high-altitude use, look for the
following label (Figure
This spark ignition system complies with Canadian ICES-002.
Contents
Introduction .................................................................. 1
Safety ........................................................................... 3
Safety and Instructional Decals ................................. 3
Setup ............................................................................ 5
1 Installing the Upper Handle.................................... 6
2 Installing the Wheel-Clutch-Cable Ends ................... 6
3 Installing the Traction-Control Linkage.................... 7
4 Installing the Chute-Control Rod ............................ 8
5 Connecting the Wire to the Headlight ...................... 9
6 Checking the Engine-Oil Level ............................... 9
7 Checking the Tire Pressure ....................................10
8 Checking the Skids and Scraper ..............................10
9 Checking the Operation of the Traction
Drive ................................................................10
Product Overview .........................................................11
Operation ....................................................................12
Before Operation ......................................................12
Safety....................................................................12
Filling the Fuel Tank ...............................................12
During Operation .....................................................12
Safety....................................................................12
Starting the Engine .................................................13
Shutting Off the Engine ..........................................15
Operating the Traction Drive ...................................15
Using the Wheel-Clutch Levers ................................16
Operating the Speed Selector ...................................16
Operating the Auger/Impeller Drive.........................16
Operating the Quick Stick®.....................................17
Unclogging the Discharge Chute ..............................17
Operating Tips ......................................................18
3).
Figure 3
After Operation ........................................................18
Safety....................................................................18
Preventing Freeze-up after Use.................................18
Maintenance .................................................................19
Recommended Maintenance Schedule(s) ......................19
Maintenance Safety.................................................19
Preparing for Maintenance.......................................19
Checking the Engine-Oil Level.................................19
Checking and Adjusting the Skids and
Scraper ..............................................................20
Checking and Adjusting the Traction Cable ................20
Checking and Adjusting the Auger/Impeller
Cable ................................................................21
Checking the Auger-Gearbox-Oil Level .....................22
Changing the Engine Oil .........................................22
Replacing the Spark Plug .........................................23
Adjusting the Discharge-Chute Latch ........................23
Replacing the Drive Belts.........................................24
Replacing the Headlight Bulb ...................................24
Storage ........................................................................25
Preparing the Machine for Storage ............................25
Removing the Machine from Storage.........................25
Troubleshooting ...........................................................26
2