Product Overview - Toro Power Max Heavy Duty 926 OXE Operator's Manual

The machine should move forward. If the machine
does not move or moves rearward, complete the
following:
A. Release the traction lever and shut off the engine.
B. Disconnect the trunnion from the speed-selector
lever (Figure 12).
C. Turn the trunnion upward (counterclockwise) on
the speed-control rod
D. Connect the trunnion to the speed-selector lever
(Figure 12).
7. If you made any adjustments, repeat this procedure
until no adjustments are required.
Important: If the machine moves when the traction
lever is in the released position, check the traction cable;
refer to Checking and Adjusting the Traction Cable
(page 20) or take the machine to an Authorized Service
Dealer for service.
(Figure 12).

Product Overview

G016495
1. Handgrip (2)
2. Auger/impeller lever
3. Speed-selector lever
4. Quick Stick® discharge
chute control
5. Traction lever
6. Fuel-tank cap
7. Oil-fill tube/dipstick
8. Chute deflector
9. Discharge chute
1
2
3
4
1. Primer
2. Ignition switch
3. Choke
4. Fuel-shutoff valve
11
Figure 20
10. Scraper
11. Auger
12. Skid (2)
13. Electric-start button
14. Electric-start plug-in
15. Snow-cleanout tool
16. Headlight
17. Wheel-clutch lever (2)
ST OP
G016500
Figure 21
5. Throttle
6. Oil-drain plug
7. Recoil-start handle
5
6
7