Operation; Before Operation; Safety; Filling The Fuel Tank - Toro Power Max Heavy Duty 926 OXE Operator's Manual

Figure 22
1. Snow-cleanout tool (attached to the handle)

Operation

Before Operation

Safety

•
Use extension cords and receptacles as specified by
the manufacturer for all machines with electric-starting
motors.
•
Do not operate the machine without wearing adequate
winter garments. Avoid loose fitting clothing that can get
caught in moving parts. Wear substantial, slip-resistant
footwear that will improve footing on slippery surfaces.
•
Always wear safety glasses or eye protection during
operation or while performing an adjustment or repair to
protect your eyes from foreign objects that the machine
may throw.
•
Thoroughly inspect the area where you will use the
machine and remove all doormats, sleds, boards, wires,
and other foreign objects.
•
If a shield, safety device, or decal is damaged, illegible, or
lost, repair or replace it before beginning operation. Also,
tighten any loose fasteners.

Filling the Fuel Tank

•
For best results, use only clean, fresh, unleaded gasoline
with an octane rating of 87 or higher ((R+M)/2 rating
method).
•
Oxygenated fuel with up to 10% ethanol or 15% MTBE
by volume is acceptable.
•
Do not use ethanol blends of gasoline (such as E15
or E85) with more than 10% ethanol by volume.
Performance problems and/or engine damage may result
which may not be covered under warranty.
•
Do not use gasoline containing methanol.
•
Do not store fuel either in the fuel tank or fuel containers
over the winter unless you use a fuel stabilizer.
•
Do not add oil to gasoline.
Important: To reduce starting problems, add fuel
stabilizer to the fuel all season, mixing it with gasoline
less than 30 days old.
1. Do not fill above the bottom of the tank neck.

During Operation

Safety
•
Rotating auger blades can injure fingers or hands.
Stay behind the handles and away from the discharge
opening while operating the machine. Keep your face,
hands, feet, and any other part of your body or
clothing away from moving or rotating parts.
•
Never direct the discharge toward people or areas where
property damage can occur.
•
Exercise caution to avoid slipping or falling. Always be
sure of your footing, and keep a firm hold on the handles.
Walk; never run.
•
Exercise extreme caution when operating on slopes.
•
Never operate the machine without good visibility or
light.
•
Look behind and use care when backing up with the
machine.
•
When not actively clearing snow, disengage power to the
rotor blades.
•
Do not attempt to clear snow from a gravel or crushed
rock surface. This product is intended for use only on
paved surfaces.
•
Do not use the machine on a roof.
•
Never attempt to make any adjustments while the engine
is running (except when specifically recommended by
manufacturer).
12
Figure 23