J6 Operation; Figure 20 Yellow Rack; Figure 21 Green Rack - Electrolux NUC1DDRUKP Manual

J6 Operation
The filling and heating phase stops when the display
shows the tank temperature:
55°C
The equipment is then ready for use:
• Open the door.
• Insert the rack with the dirty dishes.
• Close the door and select the required wash cycle;
the relevant indicator lights up and the wash cycle
starts.
• If the dishwasher is equipped with detergent and
rinse aid level sensors the message
appear on the display. This indicates no detergent
in the external tank.
After 5 cycles performed with a lack of detergent,
the dishwasher inhibits the start of other wash
cycles. Therefore the detergent level in the tank
must be restored (see par. "Manual activation").
• The lack of rinse aid is signaled by the message
 
; this message is a warning that does not
stop execution of the wash cycles.
Wash cycle selection:
- Cycle I
For not very dirty dishes or glasses: press the button
"J" (Table 2), (see times table).
- Cycle II (advisable)
For normally dirty dishes: press the button "H"
(Table 2), (see times table).
1
• To stop the wash cycle, just press the button of the
selected cycle, or open the door.
• To continue the wash, press the selected cycle button
again, or close the door. The cycle will resume from
where it was stopped.
24
55°C

1 2
2
• At the end of the wash, a series of beeps will sound
and "END" will flash on the display.
Open the door and remove the rack with the clean
dishes.
WARNING
- Our equipment cannot remove burnt grime
deposited on the dishes. Do a mechanical/
chemical pretreatment (e.g. prewash under
running water) before putting dishes with this
type of grime in the machine.
may
- The use of "foaming"/non-specific deter-
gents or in any case detergents used in differ-
ent ways from that prescribed by the
producer, can cause damage to the dish-
washer and compromise washing results.
- Failure to remove the detergent residues, pos-
sibly used for manual prewash, can cause
dishwasher malfunction and compromise
washing results.
ATTENTION
Change the tank water at least twice a day.
Rack loading type
• YELLOW rack: 18 flat plates of max width 240 mm.
• GREEN rack (optional): 12 soup plates of max
width 240 mm.
END

Figure 20 YELLOW rack

Figure 21 GREEN rack