J6 Operation; J6.1 Basket Loading; J7 Regeneration Cycle - Electrolux EGWSSIC Manual

• Cycle 1 with final a cold rinse, 120 seconds: it
corresponds to a 90 second wash cycle with hot
water and detergent, a pause of 4 seconds, a 16
second rinse cycle with hot water and shining prod-
uct and a cold rinse of 10 seconds.
A device lengthens the cycle duration if the water in
the booster has not reached the minimum temperature
for doing the rinse properly.
The cycle times and the temperature may be person-
alised (e.g. increase of the rinse time and tempera-
ture).
ATTENTION ATTENTION
The cycle times should only be set by a special-
ised technician.
J6 Operation
The wash cycle includes one wash with hot water and
detergent and one rinse with hot water and rinse-aid:

The equipment is then ready for use:
1. Open the door.
2. For the model without detergent dispenser, pour the
required amount of detergent into the tank.
3. Insert the rack with the dirty dishes.
4. Close the door and activate the required washing
cycle; the corresponding indicator lights up and the
wash cycle starts.
- Cycle 1
For not very dirty dishes or glasses.
- Cycle 2 (recommended)
For very dirty dishes.
1
- Cycle 3
For glasses and jars for beer
1
5. To stop the wash cycle, just press the cycle button
or open the door.
6. To continue the wash cycle, press the cycle button
again or close the door. The cycle starts from where it
was interrupted.
7. At the end of the wash, the dishwasher emits a

series of beeps and "
1 2
2 3
2 3
" blinks on the display:

8. Open the door and remove the rack containing the
clean dishes.
Info
Change the water in the tank some times a day, as
soon as necessary.
J6.1 Basket loading
Place cups and glasses of different dimensions up side
down in the supplied basket, using also the special
cutlery container.
Figure 12 Basket and cutlery container
Info
Baskets for washing dishes which have non stan-
dard shapes and dimensions are available on
request.
J7 Regeneration cycle
To reduce problems caused by the presence of calcar-
eous substances in the water supply, a water softener
device has been fitted in the rinse circuit of the dish-
washer. This device removes the calcareous sub-
stances from the feed-water, supplying decalcified
water necessary for the washing.
For the correct operation of the water softner, the peri-
odical regeneration of the resins, whose frequence
depends on the number of washing cycles and water
hardness, must be carried out.
This dishwasher has a built-in counter which keeps
track of how many wash cycles can be carried out
before a regeneration cycle must take place.
When the water softener device has an autonomy of
just 15 cycles left, at the end of each wash cycle the
display will alternately show the message "
the number of wash cycles (from 15 to 0) remaining

before the message "
regeneration is advised.
The relevant water supply company will be able to pro-
vide all the instructions regarding the water hardness.

" and
" appears, indicating that
21