Download Print this page

Commissioning; H1 Preliminary Checks, Adjustments And Operational Tests; H1.1 Electrical And Plumbing Checks; Tank Components Positioning Check - Electrolux NUC1DDRUKP Manual

Hide thumbs

Advertisement

H
H1
Preliminary checks, adjustments and
operational tests
ATTENTION!
These operations must only
be carried out by specialized
technicians
adequate personal protection
equipment (e.g. safety foot-
wear, gloves, glasses, etc.),
tools and ancillary means.
H1.1
Electrical and plumbing checks
Before starting the machine, it is necessary to:
check the correct connection of the electrical wires
powering the machine;
make sure the power supply voltage and frequency
match the data given in Table 1;
check the correct connection of the water supply
and discharge pipes (par. Figure 8 "Unpacking");
make sure all the guard and safety devices are in
place and efficient.
H1.2

Tank components positioning check

ATTENTION!
The following operations must
be carried out by operators pro-
vided with suitable personal
protection equipment (e.g. pro-
tective gloves, etc.) and with the
machine switched off and cold.
H1.2.1
Fitting of filters and overflow check
Make sure the tank filter "1", overflow "2" (Figure 14)
and flat filters "3" are correctly fitted (Figure 15).

Figure 14 Tank filter and overflow

18
provided
1
2

COMMISSIONING

with
H1.2.2
Make sure the upper and lower wash and rinse arms
are correctly fitted (Figure 16).
H2
Commissioning
Turn on the water supply tap.
Activate the main switch ahead of the machine by
turning it to "I".
Press the On/Off button ("A" - Table 2 "Control
panel").
H3
Detergent/rinse aid dispensers and
prearrangements
If the machine is connected to a water softener and/or
a reverse osmosis system, contact the detergent sup-
plier for a specific product.
If the peristaltic dispensers are installed in the
machine, the dosage of detergent/rinse aid is done
automatically according to the desired concentration.
The concentration of detergent/rinse aid depends on
the type of product used and the hardness of the sup-
ply water (check the characteristics on the product
label).
ATTENTION
The peristaltic dispensers (detergent and rinse aid)
and the tube inside the rinse aid dispenser require
periodical maintenance (at least once or twice a
year) or after prolonged machine idle periods.
3
3
Figure 15 Flat filters
Arm fitting check

Figure 16 Wash arms

Advertisement

loading

  Related Manuals for Electrolux NUC1DDRUKP

  Related Content for Electrolux NUC1DDRUKP