Table of Contents
Advertisement
Stemware
For lightly soiled China and Crystal. Water usage is
7.2 gallons. Wash time is approximately 87 mins.
Rinse
For rinsing dishes that will be washed later. Water
usage is 2.8 gallons. Cycle time is approximately
20 minutes.
ENERGY OPTION SELECTIONS
Hi-Temp Wash
When HI-TEMP WASH option is selected, the
dishwasher heats water in the main wash to
approximately 140°F (60°C).
This increase in water temperature helps
dishwasher detergent remove food, grease and soil
from dishes more effectively and aids in drying.
HI-TEMP WASH option can be used with all cycles
except RINSE.
When HI-TEMP WASH option is selected, the Icon
wil ligh up and remain on until end of cycle.
To turn off the HI-TEMP WASH option, press the
pad a second time. The light surrounding the pad
will turn off.
Operating Instructions
Sanitize
To sanitize your dishes and glassware, select the
SANITIZE option. When selected, the light
surrounding the pad will remain lit until the START/
CANCEL pad is pressed or the door is closed. This
option heats the water temperature in the final rinse
to 155°F (68°C) and maintains that temperature for 9
minutes. SANITIZE is available in Auto, Heavy,
Stemware and Normal cycles. Only these
sanitization cycles have been designed to meet
NSF requirements.
The cycle time will be extended until the proper
water temperature is reached. Washing action will
continue during the water heating delay. For best
results, the incoming water temperature should be
at least 120°F (49°C).
The light surrounding the pad will not illuminate at
the end of the cycle if the NSF requirements for
sanitization are not reached. The sanitization criteria
may not be satisfied if there is an interruption of the
cycle, a power failure occurs, or if the incoming
water temperature is below 120°F (49°C).
To turn off the SANITIZE option, press the pad a
second time. The light surrouding the pad will turn
off.
OPERATION SELECTIONS
Delay Start
The DELAY START option allows you to
automatically delay starting your dishwasher from
1 to 24 hours which varies by model.
Press the DELAY START pad until the desired
delay time shows in the STATUS window. A light
will come on indicating the delay start hours and
will remain on until cycle starts.
To cancel the DELAY START option and begin the
cycle before the delay period is over, press the
START/CANCEL pad.
7
Advertisement
Table of Contents
