Normal Machine Use; J1 Foreseen Use; J2 Characteristics Of Personnel Enabled To Operate On The Machine; J3 First Use - Electrolux NUC1DDRUKP Manual

J
J1 Foreseen use
Our appliances are designed and optimized to ensure
high performance and efficiency. This equipment must
only be used for its expressly designed purpose, i.e.
washing dishes with water and specific detergents.
Any other use is deemed improper.
J2 Characteristics of personnel enabled to
operate on the machine
The operator for normal machine use must at least
have:
• knowledge of the technology and specific experi-
ence in operating the machine;
• adequate general basic education and technical
knowledge for reading and understanding the con-
tents of the manual;
• including correct interpretation of the drawings,
signs and pictograms;
• sufficient technical knowledge for safely performing
his duties as specified in the manual;
• knowledge of the regulations on work hygiene and
safety.
In case of a significant anomaly (e.g. short circuits,
wires coming out of the terminal board, motor failures,
worn electrical cable sheathing, etc.) the operator for
normal machine use must:
• immediately deactivate the machine by turning the
main switch to "O";
• turn off the machine's water supply.
J3 First use
Do a couple of empty cycles to clean the tank and all
pipes from manufacturing process oils.
J4 Daily activation of the machine
• Make sure the filters, arms and overflow are cor-
rectly fitted according to that indicated in par. H1.2
"Tank components positioning check".
• Turn on the water supply tap.
• Activate the main switch ahead of the machine by
turning it to "I".
• Press the On/Off button ("A" - Table 2 "Control
panel").

NORMAL MACHINE USE

The light of button "A" (Table 2) comes on indicating
that the dishwasher is powered and is filling and heat-
ing water.
During the entire filling and heating phase the display
shows "FILL":
FILL
If the door is opened during this time the display shows
the message "CLOSE":
CLO
The filling and heating phase stops when the display
shows the tank temperature:
55°C
To display the booster temperature during tank heat-
ing, open the door and press the button "J" (Table 2).
J5 Wash cycles
Duration of standard cycle with supply water at 50°C.
Model
NUC1DDRUKP
A device lengthens the cycle duration if the water in
the booster has not reached the minimum temperature
for doing the rinse properly.
The cycle time and temperature can be customized
(e.g. increasing the rinse time and temperature).
The setting of cycle times must only be performed by
specialized personnel.
1
1
120 sec 180 sec
2
23