F5.1 Plumbing Circuits - Electrolux NUC1DDRUKP Manual

• Make sure the dynamic pressure of the water sup-
ply, measured upstream of the equipment, is
between 50 and 700 kPa (the tests must be car-
ried out while the dishwasher is filling water in the
tank and/or booster).
If the pressure is higher, install a suitable pres-
sure reducer ahead of the machine.
- For model with drain pump:
place the discharge pipe "D" (Figure 13) at a height of
between 750 mm and 1000 mm measured from the
support surface.
Subsequently check that approx. 3 litres of water come
out of the discharge pipe during the rinse phase.
F5.1 Plumbing circuits.
Plumbing circuit diagram - undercounter-type with
drain pump
LEGEND
WI = Water inlet
D = Drain
M1 = Wash pump
M2 = Drain pump
YV1 = Filling solenoid valve
V1 = Non-return valve
14