BLOTZ B28-ME-008 Instructions

28mm middle eastern building #8

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and

remember to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while

you allow glue to dry.

Remove the three walls shown above from the

Attach them to the base.

Glue them into position.

Glue these into place.

28mm Middle Eastern Building #8

B28-ME-008

Please read these instructions fully before starting construction.

PVA or equivalent glue will be required to stick sections together.

sprue.

Glue them together as shown to form a zig-zag shape.

Take the two remaining tall walls.

Then take the two remaining shorter walls.

Take the roof supports as shown above.

Table of Contents

Need help?

Do you have a question about the B28-ME-008 and is the answer not in the manual?

Page 1 28mm Middle Eastern Building #8 B28-ME-008 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.
Page 2 Glue them into place so that they extend through the wall in the same way as the ones in the Glue the door into position. building shown above. The strip with short lugs goes into the lower set of holes in the centre wall. Place (do not glue) the roof into position, then glue The completed building.