BLOTZ B28-ME-004 Instructions

28mm middle eastern building #4

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and

remember to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while

you allow glue to dry.

Remove the side and internal walls from the

Glue this to the base.

..and glue them into position.

Glue the steps into place as shown above.

28mm Middle Eastern Building #4

B28-ME-004

Please read these instructions fully before starting construction.

PVA or equivalent glue will be required to stick sections together.

sprue.

Glue them together to form an "H" shape as shown

above.

Take the front and rear walls...

Take the four sections of steps and wall....

Then glue the wall into position.

Table of Contents

Need help?

Do you have a question about the B28-ME-004 and is the answer not in the manual?

Page 1 28mm Middle Eastern Building #4 B28-ME-004 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.
Page 2 Take the roof supports as shown above. Glue them into place so that they extend through the wall (see pic). Glue the door into position. Take the main roof and door section. Glue them together as shown. Add the end support. Then place this onto the lower half of the building.
Page 3 Glue the supports into place then add the door. Place (do not glue) the upper roof into position, then glue the trapdoor to it. There is a second trap door in case you wish to have one on the main roof. The completed building.