Display Nat Outbound - H3C S9500 Series Command Manual

Command Manual – NAT
H3C S9500 Series Routing Switches
Rate control limit uses special configuration.
# Display the blacklist configurations and operation states for IP address 100.0.0.3 in
VPN1.
<H3C> display nat blacklist vpn-instance vpn1 ip 100.0.0.3 slot 4
Blacklist function global configuration:
Blacklist function is started.
Connection amount control is enabled.
Connection set-up rate control is enabled.
Amount control limit: 500 sessions.
Rate control limit: 250 session/s.
Special rate control limit: 250 session/s.
Global Committed Burst Size is 150
Special IP Committed Burst Size is 150
Control limit configuration of VPN vpn1 IP 100.0.0.3: Amount control limit:
500 sessions.
Rate control limit uses special configuration.
Blacklist running statistics of IP 100.0.0.3:
Amount of connection already set up: 0 sessions.
IP 100.0.0.3 is not in the blacklist!

1.1.6 display nat outbound

Syntax
display nat outbound
View
Any view
Parameters
None
Description
Use the display nat outbound command to display the information about all mapping
entries of NAT Outbound.
Examples
# Display the information about all mapping entries of NAT Outbound.
<H3C> display nat outbound
NAT outbound information:
Vlan-interface2 : [acl] 2000
1-5
Chapter 1 NAT Configuration Commands