H3C S9500 Series Command Manual page 26

Command Manual – NAT
H3C S9500 Series Routing Switches
undo nat static global global-addr inside [ vpn-name ] host-addr slot slot-no
nat static global global-addr1 global-addr2 inside [ vpn-name ] host-addr1
host-addr2 slot slot-no
undo nat static global global-addr1 global-addr2 inside [ vpn-name ] host-addr1
host-addr2 slot slot-no
View
VLAN interface view
Parameters
global-addr: Public network address.
global-addr1 global-addr2: A group of public network addresses.
host-addr: Private network address.
host-addr1 host-addr2: A group of private network addresses.
vpn-name: VPN name of the private network address. If this argument is not specified,
the private network address does not belong to any VPN.
slot-no: Number of the slot where the NAT service board is located.
Description
Use the nat static command to create static NAT mappings between public network
addresses and private network addresses.
After executing this command, the source IP address of a packet sent from an internal
host will be translated into the public network address specified by the global-addr
argument. External users can also access the TCP, UDP and ICMP services provided
by the internal hosts through the specified public network address.
Use the undo nat static command to remove the static NAT mappings.
Chapter 1 NAT Configuration Commands
1-25