External Antenna Connectors - Aruba 530 Series Installation Manual

External Antenna Connectors

The AP-534 access points are equipped with four external antenna connectors located on the front corners of
the access point (see
used for both radios and bands (RF signals are diplexed).
External antennas for this device must be installed by an Aruba Certified Mobility Professional (ACMP) or other
Aruba-certified technician, using manufacturer-approved antennas only.
The Equivalent Isotropically Radiated Power (EIRP) levels for all external antenna devices must not exceed the
regulatory limit set by the host country/domain.
Installers are required to record the antenna gain for this device in the system management software. A list of
approved antennas can be found at:
!
Les antennes externes pour cet appareil doivent être installées par un professionnel de la mobilité certifié Aruba
(ACMP) ou un autre technicien certifié Aruba, en utilisant uniquement des antennes approuvées par le fabricant.
Les niveaux équivalents de puissance à rayonnement isotrope (EIRP) pour tous les périphériques d'antenne
externe ne doivent pas dépasser la limite réglementaire définie par le pays hôte / domaine.
Les installateurs doivent enregistrer le gain d'antenne pour cet appareil dans le logiciel de gestion du système.
Une liste d'antennes approuvées peut être trouvée à
530Series.pdf.
LEDs
The LED displays located on the front panel of the access point indicate the following functions:
System Status
The System Status LED indicates the operating condition of the access point, See
Table 1 System Status LEDs
Color/State
Off
Green- blinking
Green- solid
Green- flashing pattern 1
Green- flashing pattern 2
Amber- solid
Amber- flashing pattern 1
Red
1 Blinking: one second on/one second off, 2 second cycle.
2 Flashing Pattern 1: mostly on, briefly off, 2 second cycle.
3 Flashing Pattern 2: mostly off, briefly on, 2 second cycle.
Radio Status
The Radio Status LED indicates the operating mode of the access point's radios. See
2
Figure 2). Antenna ports A0 through A3 (corresponding with radio chains 0 through 3), are
http://www.arubanetworks.com/assets/og/OG_AP-530Series.pdf.
Meaning
Device powered off
Device booting, not ready
1
Device ready, fully functional, no network restrictions
2 Device ready, fully functional, either uplink negotiated in sub-optimal speed
(<1Gbps)
Deep sleep mode
3
Device ready, restricted power mode (limited PoE power available, or IPM
restrictions applied), no network restrictions
Device ready, restricted power mode (limited PoE power available, or IPM
restrictions applied), uplink negotiated in sub-optimal speed (<1Gbps)
System error condition - Immediate attention required
http://www.arubanetworks.com/assets/og/OG_AP-
Aruba 530 Series Campus Access Points | Installation Guide
Table 1.
Table 2.