External Antenna Connectors - Aruba 210 Series Installation Manual

LED
The AP-210 Series is equipped with four LEDs that indicate the status of the various components of the AP.
PWR: Indicates whether or not the AP-210 Series is powered-on

ENET: Indicates the status of the AP-210 Series' Ethernet port

5 GHz: Indicates the status of the 802.11a/n radio

2.4 GHz: Indicates the status of the 802.11b/g/n radio

Table 1
LED
PWR
ENET
5 GHz
2.4 GHz
Figure 2

External Antenna Connectors

The AP-214 is equipped with three external antenna connectors. The connectors are labeled ANT0, ANT1, and
ANT2, and correspond to radio chains 0, 1, and 2.
For optimal performance when using articulating direct-mount antennas, professional installers must orient the
antennas with ANT0 and ANT2 at 45 degree angles and ANT1 oriented straight out
2
AP-210 Series Series LED Meanings
Color/State
Off
Green - Flashing
Green - Steady
Off
Yellow - Steady
Green - Steady
Flashing
Off
Yellow - Steady
Green - Steady
Flashing - Green
Off
Yellow - Steady
Green - Steady
Flashing - Green
AP-210 Series Side View (AP-214 shown)
ANT2
Meaning
No power to AP
AP booting
AP ready
Ethernet link unavailable
10/100Mbps Ethernet link established
1000Mbps Ethernet link established
Ethernet link activity
5 GHz radio disabled
5 GHz radio enabled in non-HT WLAN mode
5 GHz radio enabled in HT WLAN mode
5 GHz Air or Spectrum Monitor
2.4 GHz radio disabled
2.4 GHz radio enabled in non-HT WLAN mode
2.4 GHz radio enabled in HT WLAN mode
2.4 GHz Air or Spectrum Monitor
ANT1
ANT0
USB Port
Aruba 210 Series Access Points | Installation Guide
(see Figure 3).