Table of Contents
Advertisement
Figure 5
Ethernet Ports
The Aruba 530 Series access points are equipped with two active Ethernet ports (Eth0 and Eth1), shown in
3. Both ports are 100/1000/2500/5000 Base-T, auto-sensing MDI/MDX, which supports uplink connectivity when
linked by an Ethernet cable. Refer to
Figure 6
Kensington Lock Slot
The 530 Series is equipped with a Kensington lock slot for additional physical security.
USB Interface
The top of this access point is equipped with a USB-A host port that is compatible with cellular modems and
other selected peripherals. When active, this port can supply up to 5W/1A to a connected device.
Figure 7
Reset Button
The reset button located on the bottom of the device can be used to reset the access point to factory default
settings or turn off/on the LED display.
Use one of the following methods to reset the access point to factory default settings:
To reset during normal operation:
To reset during power up, hold the reset button while the access point is powering up.
The system status LED will flash again within 15 seconds indicating that the reset is completed. The access
point will now continue to boot with the factory default settings.
To toggle the LED display between Off and Blinking:
Aruba 530 Series Campus Access Points
Micro-B Port Pin-out
Ethernet Port Pin-Out
AP-534 (USB)
1.Hold the reset button for more than 10 seconds while the access point is running.
2.Release the reset button.
| Installation Guide
Figure 6
for a detailed port pin-out.
Signal Name
RJ45 Female
Pin-Out
BI_DA+
1
BI_DA-
2
BI_DB+
3
BI_DC+
4
BI_DC-
5
BI_DB-
6
BI_DD+
7
BI_DD-
8
1: NC
2: RXD
3: TXD
4: GND
5: GND
Function
Bi-directional pair +A
Bi-directional pair -A
Bi-directional pair +B
Bi-directional pair +C
Bi-directional pair -C
Bi-directional pair -B
Bi-directional pair +D
Bi-directional pair -D
Figure
5
Hide quick links:
Advertisement
Table of Contents
