Selecting An Antenna; Maintenance - Aruba AP-60 Installation Manual

AP Deployment
Chapter 2

Selecting an Antenna

There are three ways to select an AP-60 antenna:
From the AP console (serial or telnet) enter set_antenna 0|1|2 where 0
1.
specifies auto mode, and 1 or 2 chooses a specific antenna. The antenna
selection is not persistent and the AP will loose the antenna selection, if
rebooted.
From the AP boot prompt (apboot>) enter a_antenna 0|1|2 or g_antenna 0|1|2
2.
to specify an antenna. Enter a save command before booting the AP to save
the antenna configuration in the AP's Flash memory, along with other
provisioning parameters.
3. For releases 2.3 and higher, you can provision the antenna selection from the
Mobility Controller.

Maintenance

The AP-60 and AP-61 require no maintenance beyond keeping the AP clean and
dust free. To clean the Aruba AP-60/61, use a static-free, dry cloth.
Aruba recommends that these units be inspected annually for damage, dust
buildup, and to verify that all connections are secure.
16 Aruba AP-60/61
Installation Guide
0510160-03
April 2008