Flying With The System; On The Ground; Power-On Procedure; Profile Selection - LXNAV LX90 Series Manual

Hide thumbs Also See for LX90 Series:
Table of Contents

Advertisement

Rev #1

Flying with the System

To get the best out of the system it is important that some preparation is done prior to take-
off. Trying to configure the instrument or set a task while flying is very hazardous especially
in a competition. At least, it could spoil your whole day! Pre-flight preparation will ensure
that the flight will be both safe and enjoyable.

6.2 On the Ground

6.2.1

Power-On Procedure

Press the power-on button. The main display unit and the vario unit will turn on and a few
moments later welcome screen will appear. The first screen shows the version of the boot
loader followed by the version of the Linux kernel operating system, then the version of the
file system. The boot procedure normally takes 10 seconds. When completed the profile
selection dialogue is shown.
It is recommended to switch the unit ON some minutes prior to take-off to give
the GPS receiver time enough to acquire satellites. The flight recorder will also
make a take-off baseline. Longer running on the ground will not reduce flight
recorder capacity.
6.2.2

Profile Selection

Turn the PAGE selector knob to select the desired profile if more than one profile is
available. First profiles stored in internal storage are displayed, then profiles on SD card are
shown and finally profiles on a USB stick are shown. You will note that a profile resides on
the SD card/USB stick by a small SD card/USB stick symbol in the lower-right part of the
pilot icon.
For the selected profile the pilot name, glider type, loaded waypoint files, loaded airports
databases and loaded airspace databases are shown.
If a file is stored on a SD card or USB stick, a label [SD] or [USB] will appear in front of file
name.
To learn more about profiles refer to Section 5.1.9. Press the SELECT button to confirm
selection of the profile.
settings. The set elevation dialogue will follow.
Version 7.10
Press the DEFAULT button to start the system with default
Page 124 of 145
January 2020

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lx80 seriesLx900Lx905Lx907Lx800Lx808

Table of Contents