Huawei SE2900 Hardware Description page 45

HUAWEI SE2900 Session Border Controller
Hardware Description
Silk
Scre
en
ACT
LIN
K
eFabr
ic
LAN
0/LA
N1
Base
LAN
0/LA
N1
In the cascading environment, if the MXUA0 GPC in the slave subrack is isolated, the GPC is powered
off, the OFL indicator is off, and the OFL button is unavailable.
Issue 01 (2016-01-15)
Meani
State
ng
Steady green
Networ Off
k port
indicat
Blinking yellow
or
Networ
Green
k port
indicat
Off
or
Indicat Off
or of
Steady green
the
cascadi
ng port
of the
Blinking green
eFabric
plane
Indicat Green off
or of
Steady green
the
cascadi
Yellow off
ng port
of the
Base
Blinking yellow
plane
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
State Description
An indicator in the on state stands for the binary digit
1.
To set the subrack number, hold down the DIP button
for 6 seconds until the indicators enter the setting
mode, press the DIP button to set the subrack
number, and then hold down the DIP button for 6
seconds to complete the setting.
Binary numbers 000 to 111 indicate subrack numbers
0 to 7 respectively.
NOTE
 The subrack number can be set only on the active SMM.
The standby SMM only supports indicator test mode.
 If you do not press the DIP button within 30 seconds after
the indicators enter the setting mode, the indicators exit
the setting mode without saving the settings.
 Each time you press the DIP button, the subrack number
increases by 1. The subrack number restarts from 0 after
it passes 7.
The port is not sending or receiving data.
The port is sending or receiving data.
The link is connected.
The link is faulty or disconnected.
The link is faulty or disconnected.
The link is connected.
The port is sending or receiving data.
The link is faulty or disconnected.
The link is connected.
The port is not sending or receiving data.
The port is sending or receiving data.
1 Service Processing Device
41