Install - Haug EN 8 SLC MT Operating Instructions Manual

4 Install

Risk of explosion!
The discharging power pack may generate sparks which ignite
gases, dust or similar substances.
• Never install or use the discharging power pack in areas with
Electric shock hazard!
An electric shock hazard results from a faulty connection of the
discharging power pack to the power supply.
• The discharging power pack must only be installed by a trained
Damage to equipment!
Continuous overloading of the discharging power pack may result in
failures.
• Never exceed the permissible connected length.
• Never install the discharging power pack on a surface generating
• Never install at a location subject to direct solar irradiation.
1. Check the model plate of the discharging power pack against the
2. Before connecting the
potentially explosive atmospheres.
and qualified electrician.
or radiating heat.
ordering data. In the event of damage to the discharging power
pack, contact HAUG GmbH & Co. KG.
cooling unit, ensure that the
correct supply voltage is
available for the
discharging power pack.
• The type plate attached
to the housing indicates the voltage.
• If the supply voltage is incorrect, the discharging power pack
may be damaged.
4 Install
9