Table of Contents
Advertisement
Enhanced Radius Function (Auto-R): Continued...
Navigate to the Tool compensation entry and select the Tool Cut edge.
If you have a 3-axes Mill all the parameters have now been entered.
Press the
key to enter machining mode.
The following parameters may not appear on ALL plane selections / DRO types (2x / 3x).
Navigate to the Max Cut entry and enter the required value.
Once all the parameters have been entered you can check them by going back through them using the
navigation key . Alternatively you can also start using the function immediately by pressing the
The execution of the function varies between 2-axes and 3-axes DRO for the YZ & XZ planes as we have to
use the Z-dial calibration performed in Setup to simulate the Z-axis on 2-axes DRO systems.
R - Tool
R - TOOL
MAX CUT
.
The EM250 will use this as the maximum step value and automatically
calculate the best possible axis increment according to the curvature of
the ARC to be approximately equal to the MAX CUT value.
- 35 -
R + TOOL
R + TOOL
MAX CUT
.
key once more.
Advertisement
Table of Contents
