Table of Contents
Advertisement
The following is the operating mode on XZ & ZY Plane on 3-axes DRO.
.
Move the Z-axis by the programmed Max-Cut value. This will cause the X-axis display to also change. When the Y-
axis move is complete, then move the X-axis until the X-axis shows
inclined machining operation is completed.
The Y-axis position increments by the Max-Cut value each time. As the machining is at a given angle the
X-axis value will be the same for each step and will depend on the angle of cut.
The following is the operating mode on XZ & ZY Plane on 2-axes DRO.
X-axis value
Z-axis rotations
Z-axis simulated
dial reading
Move X-axis to zero and then move the Z-axis. When you have moved the Z-axis use the message navigation keys to
inform the DRO that the movement has been completed, and move to the next point. This process can be repeated
until the inclined machining operation is completed.
AUTO
XZ
.
.
.
AUTO
XZ
.
.
.
AUTO
XZ
.
.
.
Z-
.
.
Z-
.
Press the Function key to exit
when the operation is complete.
The message window will show the current plane of
operation and the X-axis display is left aligned to indicate
that it is operating in a special mode.
Z-axis simulated
0.250
DRO reading
0.250
- 27 -
.
. This process can be repeated until the
.
AUTO
.
.
.
AUTO
.
.
Repeat as required...
The DRO will simulate a Z-axis position
based on the DIAL INC and Z DIAL
values configured in Setup. It is the
operators responsibility to move the
dials as per the DRO display.
.
.
Repeat as required...
.
XZ
XZ
Z-
0.500
Advertisement
Table of Contents
