Table of Contents
Advertisement
Example: Set Tool-Offset to 10.5mm for Tool #1 (Continued)
The entered value is that of the measured RADIUS.
The Tool Offset is now defined. Can repeat this procedure to set other Tool Offsets by simply selecting the next
tool to set by using the Tool navigation keys.
Exit the Tool Offset configuration:
TOOL FUN
.
If a value is shown other than
Tool Offset value is being applied.
Turn Off Tool-Offsets:
To turn off Tool-Offsets you can either use the tool navigation keys to Tool "
simply pressing the
.
ABS
.
Selecting a Tool-Offset:
.
ABS
.
"
"
in the Tool display then that
key.
- 15 -
IN OFFST
.
TOOL FUN
.
.
ABS
.
The last Tool is shown in Tool display and is
actively being applied.
" or by
.
ABS
.
.
IN TOOL
.
Tool Offsets are now operational but not
yet applied as we are still at tool '
'
Advertisement
Table of Contents
