Table of Contents
Advertisement
Inclined Machining: Continued...
Navigate to the plane Angle entry and enter the required value.
Navigate to the Max Cut entry and enter the required value.
Once all the parameters have been entered you can check them by going back through them using the
navigation key . Alternatively you can also start using the function immediately by pressing the
The execution of the function varies between 2-axes and 3-axes DRO for the YZ & XZ planes as we have to
use the Z-dial calibration performed in Setup to simulate the Z-axis on 2-axes DRO systems.
The following is only required for the XY Plane. (2-axis and 3-axis DRO)
Move the X-axis and Y-axis to
until the ARC machining operation is completed. You can navigate through the points using the
.
.
.
.
INCL
ANG
.
MAX CUT
.
.
PT
1
.
.
.
. Then press the
PT
1
.
PT
2
.
The message window will show the first machining Point
with the X & Y-axis displays left aligned to indicate that it
is operating in a special mode.
key to move to the next next point and repeat the process
- 26 -
.
.
.
PT
.
.
.
PT
.
.
Repeat as required...
INCL
ANG
MAX CUT
key once more.
keys
2
3
Advertisement
Table of Contents
