Table of Contents
Advertisement
Line-Hole Function: Continued...
Enter the line angle.
Use the Message
Navigation keys
Enter the line number of holes.
Once all the parameters have been entered you can check them by going back through them using the
navigation key . Alternatively you can also start using the PCD immediately by pressing the
.
.
Navigate between holes using the Message navigation keys.
Check ABS position whilst in the Line-Hole Function
If at any time whilst in the Line-Hole function you would like to check the standard ABS position, relative to the
workpiece datum this can be done using the
you have checked the positions re-enter the function offset display by again pressing the
.
HOLE
.
LIN
ANG
.
NO. HOLE
.
HOLE
1
.
HOLE
2
.
1
The message window will show the current selected Hole
number and the X and Y-axis will show the offset to the
centre of that hole. By moving the axes until they are
.
both showing
hole centre.
key. The Line-Hole function is still active in the background. Once
.
HOLE
1
.
- 24 -
.
key once more.
you will now be at the calculated
.
HOLE
.
key.
.
.
LIN
ANG
NO. HOLE
1
HOLE
1
Advertisement
Table of Contents
