Table of Contents
Advertisement
Simple Radius Function (R-Function): Continued...
The following is the operating mode on XZ & ZY Plane on 3-axes DRO.
.
Move the Z-axis by the programmed Max-Cut value. This will cause the X-axis display to also change. When the Y-
axis move is complete, then move the X-axis until the X-axis shows
inclined machining operation is completed.
Check ABS position whilst performing R-Function Machining (ALL DRO)
If at any time whilst in the R-Function you would like to check the standard ABS position, relative to the workpiece
datum, this can be done using the
the positions re-enter the R-Function mode by again pressing the
.
AUTO
.
.
AUTO
XZ
.
.
.
AUTO
XZ
.
.
.
AUTO
XZ
.
.
key. The function remains active in the background. Once you have checked
XZ
The message window will show the current plane of
operation and the X-axis display is left aligned to indicate
that it is operating in a special mode.
If the message window displays "Z OU LI" it means that the Z-
axis is outside of the line of the calculated ARC.
.
key.
.
AUTO
XZ
.
.
- 32 -
.
. This process can be repeated until the
.
AUTO
.
.
.
AUTO
.
.
.
.
.
XZ
XZ
AUTO
XZ
Advertisement
Table of Contents
