LEAB ABC 1215 User Manual page 15

Installation Instructions
Connect the Device to the 230-V Mains
To install the device to the 230-V mains, perform the following step:
1. Connect the mains plug to a 230-V mains supply.

The charger is only suitable for connection to fused, earthed
230-V networks.

For devices without an on/off switch, the device switches on
as soon as a voltage is applied.
The charger is connected to the 230-V mains supply.
Connect Remote Display (Optional)
The remote display shows the charging status of the battery with an LED.
To connect the remote display, perform the following steps:
1. Plug the connecting cable for the remote display into the connector for
the remote display.
The remote display is connected.
Connect Sensor Cable (Optional)
The sensor cable measures the battery temperature (sensor cable TS) or the
battery temperature and voltage (sensor cable CTS) in order to charge the
battery optimally.
When connecting, pay attention to the instructions and notes in the
installation instructions for the sensor cable.
Page 14 of 18
Installation