Operating Instructions - Dexter Laundry T-30 Original Instructions Manual

Maximum Load Capacity: 13.6 kg (30 Pounds) Dry Weight for DN0030E_
Maximum Load Capacity: 22.7 kg (50 Pounds) Dry Weight for DN0050E_
Maximum Load Capacity: 36.4 kg (80 pounds) Dry Weight for DN0080E_
To dry a load of items, you must choose one of the five-programmed dry cycles. Each of
these five dry cycles may be modified in two different ways to match your load. Please refer
to the "Permanent Dryer Controller Programming" or "Temporary Dryer Controller
Programming" section of this manual.
There are two parts to each dry cycle. The first part is the heating time, which is when the
heating elements is cycled on and off according to the temperature setting in the dry cycle
program. The second part is the cool down time, which is after the heating part of the dry
cycle, and is when the cylinder continues to turn, but no heat is applied to prevent damage
from heat.
There will always be at least two minutes of cool down time for each dry cycle to prevent
damage from heat. The maximum amount of cool down time is 60 minutes.
The default value of the five dry cycles is shown in the "DRYER CONTROLLER FACTORY
DEFAULT PROGRAM SETTINGS" table in this manual.
To improve the drying capabilities of this dryer, you should always separate (untangle) the
individual articles in your load before using the dryer.
In the following instruction steps, things that are displayed on the 4-digit numerical display
will be in "quotation marks" and any touch pad switches on the dryer controller that physically
need to be pressed will be in CAPITAL AND BOLD LETTERS.
1) Place your untangled load into the dryer cylinder and close the dryer loading door. Notice
that the dryer controller 4-digit numerical display should show the word "LOAd". If it does
not show this word, then press and release the STOP touch pad switch on the dryer
controller twice.
2) Press and release the UP or DOWN touch pad switch on the dryer controller to select a
dry cycle.
3) Once the desired dry cycle is selected, press and release the START touch pad switch.
After the dryer controller START touch pad switch is pressed, the dryer cylinder will start
rotating and the two-digit total dry cycle time, along with a decimal point, will appear on the
dryer controller display.
The time shown on the dryer controller display will count down to the programmed cool
down time. At that time, the display will change from the decimal point and two-digit number
to a letter "C" and two digits.
The letter "C" represents the cool down portion of the dry cycle. The two digits represent
the amount of time remaining in the dry cycle. The two-digit time, shown on the dryer
controller display, will count down to zero.
8514-219-001 REV E PAGE 17

OPERATING INSTRUCTIONS