Download Print this page

Advertisement

Quick Links

Original Instructions
For use in GB & IE
for DCBD30KC-64F Series Dryers
The dryer will operate correctly in ambient temperatures of +5°C to +40°C, in relative
humidity up to 50% at +40°C and above 50% when below +40°C, and at altitudes up to
1000m above sea level, must be transported and stored from -40°C to +140°C, and has
been packaged to prevent damage from humidity, vibration, and shock. Take measures to
avoid harmful effects of occasional condensation.
"For Your Safety"
Post the following
Do not store or use petrol or other flammable vapours and liquids or dry cleaning solvents in
the vicinity of this or any other appliance.
THIS MACHINE IS FOR DRYING ONLY FABRICS CLEANED IN WATER.
To avoid possibility of fire, including spontaneous combustion, do not dry oiled floor mops,
items containing foam rubber or similarly textured rubberlike materials or any material on
which you have used a cleaning solvent or which contains flammable liquids or solids (such
as petrol, kerosene, waxes, etc.) Fabric softeners, or similar products, should be used per the
fabric softener instructions. Remove all objects from pockets such as lighters and matches.
WARNING – Risk of Fire
Clothes dryer installation must be performed by a qualified installer.
Install the clothes dryer according to the manufacturer's instructions and local codes.
Do not install a clothes dryer with flexible plastic venting materials. If flexible metal (foil type)
duct is installed, use duct that has been investigated and found acceptable for use with
clothes dryers. Flexible venting materials are known to collapse, be easily crushed, and trap
lint. These conditions will obstruct clothes dryer airflow and increase the risk of fire.
To reduce the risk of severe injury or death, follow all installation instructions.
This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning use of the appliance in a safe
way and understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
It is important that you read this Manual and retain it for future reference. For service
or replacement parts, contact the distributor in your area or:
8514-218-001A
OPERATOR'S MANUAL
caution in a prominent location:
FOR YOUR SAFETY
FOR YOUR SAFETY
Dexter Laundry, Inc.
2211 W. Grimes
Fairfield, Iowa 52556, USA
July 2013

Advertisement

loading
Need help?

Need help?

Do you have a question about the DCBD30KC-64F Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Dexter Laundry DCBD30KC-64F Series

  • Page 1 For use in GB & IE OPERATOR’S MANUAL for DCBD30KC-64F Series Dryers The dryer will operate correctly in ambient temperatures of +5°C to +40°C, in relative humidity up to 50% at +40°C and above 50% when below +40°C, and at altitudes up to 1000m above sea level, must be transported and stored from -40°C to +140°C, and has...
  • Page 2: Table Of Contents

    TABLE OF CONTENTS DRYER DIMENSIONS (Figure 1)................. UNCRATING..................... DRYER INSTALLATION..................DRYER EXHAUST SYSTEM (Figure 2)..............DRYER SHUTDOWN..................OPERATING INSTRUCTIONS................PROGRAMMING INSTRUCTIONS................ SERVICING THE DRYER..................PREVENTATIVE MAINTENANCE................. WARNINGS ABOUT USE AND OPERATION Caution! There are sharp edges on various sheet metal parts internal to the enclosure.
  • Page 3 WARNINGS ABOUT USE AND OPERATION continued A DRYER SHOULD BE CONNECTED TO POWER FOR THREE (3) MINUTES before it is operated or before a program change is made. Operation or program changes which occur during this “power up” period are subject to loss in case of power interruption. After the initial three minutes, all programmed data is protected from power interruptions of any length and the customer’s individual cycle is protected up to 3 seconds.
  • Page 4: Dryer Dimensions (Figure 1)

    72 ¼ (1835) 41 ¼ (1048) LEVELING LEGS SHOWN IN MINIMUM HEIGHT POSITION FOR MAXIMUM HEIGHTS, ADD 1" (25 mm) 31 ½ (800) DRYER DIMENSIONS - FIGURE 1A...
  • Page 5 ELECTRIC CONNECTION 70 ⅝ (1794) 62 ⅝ (1591) 42 (1067) 2 (51) DRYER DIMENSIONS - FIGURE 1B...
  • Page 6 ELECTRIC CONNECTION 19 ¼ (489) 4 ¾ (121) 34 ⅛ (867) Ø8 (203) EXHAUST 36 ⅞ (937) DRYER DIMENSIONS - FIGURE 1C...
  • Page 7: Uncrating

    INSTALLATION AND OPERATING INSTRUCTIONS UNCRATING AND PLACING DRYER Tools Required: 3/4" (19 mm) hex socket and ratchet driver, a knife, and a channel-lock wrench, which will open to 1 3/8" (35 mm). 1. Remove the plastic wrap with the knife. Remove cardboard rails, fillers, and top cap. 2.
  • Page 8 VERTICAL CLEARANCE DIMENSIONS - ALL DCBD30 3. MAKE-UP AIR. Adequate make-up air must be supplied to replace air exhausted by dryers on all types of installations. Provide a minimum air opening to the outside for each dryer as follows: Dryer Model Make-up Air Volume/Time Make-up Air Opening Size (minimum) DCBD30KC-64F...
  • Page 9 HEATING ELEMENT SUPPLY VOLTAGE MINIMUM DUAL ELEMENT MINIMUM WIRE SIZE FROM FUSED SIZE (kW) TIME DELAY FUSE SIZE AT DISCONNECT TO DRYER TERMINAL PHASE / V. FUSED DISCONNECT (A.) BLOCK (75 C COPPER WIRE) 3 / 400 The installation must meet the electrical requirements of the country of installation. The installer must provide a disconnect switch, which will interrupt all lines.
  • Page 10 due to pipe size or type of installation can cause slow drying time, excessive heat, and lint in the room. From an operational standpoint, incorrect or inadequate exhausting can cause a cycling of the high limit thermostat, which shuts off the heating elements and results in inefficient drying.
  • Page 11: Dryer Shutdown

    individual ducts from the dryers can enter at the sides or bottom of the main discharge duct. Figure 2 indicates the various round main duct diameters to use with the individual dryer ducts. The main duct can be rectangular or round, provided adequate airflow is maintained. For each individual dryer, the total exhausting (main discharge duct plus duct outlet from the dryer) should not exceed the equivalent of 20’...
  • Page 12: Operating Instructions

    OPERATING INSTRUCTIONS Maximum Load Capacity: 13.6 kg Dry Weight for DCBD30KC-64F 1. Deposit coins to satisfy vend price display of idle dryer. Each deposit decreases the vend price until the display changes to show the amount of time purchased. LOW light illuminates.
  • Page 13 PROGRAMMING: All operating parameters (vend price, temperatures, cool-down times, etc.) are adjustable. There are also several displays of information available from the controller (money audits, hours run, dryer temperature.) The dryer is shipped ready for operation with the following pre-programmed data: Temperature- HIGH: 175°F / 78°C...
  • Page 14: Programming Instructions

    PROGRAMMING INSTRUCTIONS: (To switch to program mode.) 1. Unlock and raise the upper service door until it can be held in place by the pivoting wire support. 2. Open the loading door. 3. Push the Program Button found just to the left of the LOW light.
  • Page 15 ORDER OF PROGRAMMING STEPS: CYCLE LIGHTS DISPLAY PROGRAMMING STEP DESCRIPTION OPTIONS/RANGE HOUR METER Displays hours of timer operation. May be reset to zero HIGH, MED, Number of pulses from the left acceptor (dual coin __ __ LEFT MONEY AUDIT May be reset to zero. models).
  • Page 16: Servicing The Dryer

    AVAILABLE OPTIONS The following two features are available in the dryer. Disconnect power from the machine for two minutes before modifying the machine for either option. Anti-Wrinkle Option The dryer is shipped with this feature defeated. As shipped, when the machine stops at the end of the cycle, the load will sit motionless in the machine until the user removes the load.
  • Page 17 9822-026-002 SERVICE MANUAL 8533-076-001 For service and parts information, contact your local Dexter agent. If a Dexter agent is not available, contact Dexter Laundry, Inc. directly as listed below: Mailing Address: 2211 West Grimes Avenue Phone: 1-800-524-2954 Fairfield, IA 52556 USA Website: www.dexterlaundry.com/...
  • Page 18 DOW CORNING -- MOLYKOTE BR2-S GREASE -- 9150-00K000170 ================== Product Identification ===================== Product ID: MOLYKOTE BR2-S GREASE MSDS Date: 01/01/1985 FSC: 9150 NIIN: 00K000170 MSDS Number: BBZNK ==================== Responsible Party ===================== Company Name: DOW CORNING Emergency Phone Number: 517-496-5900 CAGE: 5D028 ================== Contractor Identification =================== Company Name: DOW CORNING CORP Address: 3901 S SAGINAW RD Box: 997...
  • Page 19 Conforming Commercial Drying System Machinery: Model Numbers: DCBD30 Serial Numbers: Manufacturer: Dexter Laundry, Inc., 2211 West Grimes Avenue, Fairfield, IA 52556 USA Harmonised BS EN 349:1993 Safety of machinery. Minimum gaps to avoid crushing Standards +A1:2008 of parts of the human body.
  • Page 20 WITH COUNCIL DIRECTIVE 2004/108/EC Directive: Electromagnetic Compatibility Directive 2004/108/EC Conforming Commercial Drying System Machinery: Model Numbers: DCBD30 Manufacturer: Dexter Laundry, Inc. 2211 West Grimes Avenue Fairfield, IA 52556 USA Harmonised BS EN 55014-1:2006 Electromagnetic compatibility. Requirements for Standards +A1:2009 household appliances, electric tools and similar Referenced apparatus.
  • Page 21 Declaration of Noise Emission The Dexter Laundry Commercial Drying System Models Sound Pressure Levels per EN ISO 11202 as measured on similarly constructed models are as follows: Model DCBD30KC-64FN Operating Idle 61 dB (A) 54 dB (A) (Operator Position) 68 dB (A)

This manual is also suitable for:

Dcbd30kc-64fn