Hyundai KONA Owner's Manual page 362

Driving your vehicle
LKA operation
To activate/deactivate the LKA system:
With the ignition switch in the ON
position, press the LKA system button
located on the instrument panel on the
left hand side of the steering wheel
(Right hand side of the steering wheel for
RHD vehicles.).
The indicator in the cluster
display will initially illuminate white. This
indicates the LKA system is in the READY
but NOT ENABLED state.
Note that the vehicle speed
must be at least approximately
60 km/h (40 mph) to ENABLE
the LKA system. The indicator
in the cluster display will
illuminate green.
- White: Sensor does not detect lane
markers (or road edges) or vehicle
speed is under 60 km/h (37 mph).
- Green: Sensor detects lane markers
(or road edges) and the system is able
to control vehicle steering.
6-86
Information
If the indicator (white) is activated from
the previous ignition cycle, the system will
turn ON without any additional control.
If you press the LKA button again, the
indicator on the cluster goes off.
LKA system operation
OOSH069080L
• To see the LKA screen on the LCD
display in the cluster, select ASSIST
mode (
refer to "LCD Display Modes" section
in chapter 4.
OOSH069081L
). For more information,