Hyundai KONA Owner's Manual page 196

Convenient features
NOTICE
• Do not attempt to disassemble
the front view camera without the
assistance of an authorized HYUNDAI
dealer technician. If camera is
removed for any reason, the system
may need to be recalibrated. We
recommend that the system be
inspected by an authorized HYUNDAI
dealer.
• If the windshield of your vehicle is
replaced, most likely the front view
camera will need to be recalibrated.
If this occurs, we recommend
that the vehicle be inspected and
have the system recalibrated by an
authorized HYUNDAI dealer.
• Be careful that water doesn't get into
the High Beam Assist (HBA) unit and
do not remove or damage related
parts of the High Beam Assist (HBA)
system.
• Do not place objects on the
dashboard that reflect light such as
mirrors, white paper, etc. The system
may not be able to function properly
if sunlight is reflected.
• At times, the High Beam Assist (HBA)
may not work properly. The system
is for convenience only. It is the
responsibility of the driver for safe
driving practices and always check
the road conditions for your safety.
• When the system does not operate
normally, change the headlamp
position manually between the high
beam and low beam.
5-46
Turn signals and lane change signals
To signal a turn, push down on the lever
for a left turn or up for a right turn in
position (A).
If an indicator stays on and does not flash
or if it flashes abnormally, one of the turn
signal bulbs may be burned out and will
require replacement.
One touch turn indicator function
To activate the One Touch Turn Indicator
function, push the turn signal lever up or
down to position (B) and then release it.
The lane change signals will blink 3, 5 or
7 times.
You can activate or deactivate the One
Touch Turn Indicator function or choose
the number of blinks (3, 5, or 7) from the
User Settings mode in the LCD display.
For more details, refer to the "LCD
Display Modes" section in chapter 4.
OOSH059051L