6.3. Preparation for the Controller Setup
Prepare the Controller settings.
Install Power PMAC IDE and Acontis EC-Engineer on the computer in advance.
6.3.1.
Creation of a New Project
1
Turn on the power to the
Controller.
2
Start Power PMAC IDE.
* If the dialog for confirming
access rights appears upon
start-up, select starting of
Power PMAC IDE.
3
The Communication screen
appears. Specify the IP address
of the destination Controller and
click Connect.
* The IP address of the
Controller is set to
"192.168.0.200" by default.
* If necessary, change the
Windows IP address to
"192.168.0.X".
24