Table of Contents
Advertisement
WeatherTRAK ET Pro2 SWM to WeatherTRAK ET Pro3
Upgrade Installation Instructions
Step 1 - Remove the Command Module and Disconnect the Power
Loosen the 4 corner pop-up screws. Lift the command module then turn it over.
Carefully unplug the power cable from the mini-chassis.
Step 2 - Disconnect the power cable from the mini-chassis
Disconnect the antenna cable from the back of the command module.
Disconnect the ribbon cable from the back of the command module.
Remove the command module and set aside.
©2018 HydroPoint Data Systems, Inc. All Rights Reserved
Upgrade Instructions
3
800.362.8774 • hydropoint.com
Advertisement
Table of Contents
Need help?
Do you have a question about the WeatherTRAK ET Pro2 SWM and is the answer not in the manual?