Contents; Getting Started; Overview Of The Steps For Included Equipment; Swm To Et Pro 3 - HydroPoint WeatherTRAK ET Pro2 SWM Upgrade Installation Manual

WeatherTRAK ET Pro2 SWM to WeatherTRAK ET Pro3
Upgrade Installation Instructions
Thank you for purchasing the WeatherTRAK ET Pro3 upgrade kit.
WeatherTRAK ET Pro3 is the industry's most powerful cloud-based outdoor water management
controller, providing top of the line technology and innovation. The higher station count
option, additional flow management and monitoring, and increased scheduling flexibility make
upgrading from the older WeatherTRAK ET Pro2 SWM controller a good decision.
Overview of the Steps for Upgrading from ET Pro 2 SWM to ET Pro3
To upgrade your controller, you need to perform the following steps:
Step 1 - Remove the command module and disconnect the power.
Step 2 - Disconnect the antenna and ribbon cable.
Step 3 - Transfer the station keys from the Pro2 SWM to the Pro3.
Step 4 - Disconnect the rain sensor.
Step 5 - Label and disconnect the valve wires.
Step 6 - Remove the ET Pro2 SWM mini-chassis.
Step 7 - Install the ET Pro3 mini-chassis.
Step 8 - Reconnect the valve wires and rain sensor.
Step 9 - Install the ET Pro3 command module.
Step 10 - Update the date and time.
Step 11 - Activate controller with HydroPoint.
Step 12 - Test the new ET Pro3 Controller.
Included Equipment
•
Pro3 command module
•
Pro3 mini-chassis
•
3G modem
•
Ribbon cable
©2018 HydroPoint Data Systems, Inc. All Rights Reserved

Getting Started

1
800.362.8774 • hydropoint.com