National Instruments MXI-2 Series Getting Started page 39

Chapter A Default Settings — VXI/VME-MXI-2
PCI-Based MXI-2 Interface for Windows
Table A-9. VXI-MXI-2/B Hardware Default Settings (Continued)
Hardware Component
SMB CLK10 termination (S6)
Polarity of external SMB CLK10
(S3)
MXIbus CLK10 signal (S1)
MXIbus termination
(U21 Switches 3 and 4)
Configuration EEPROM
(U21 Switches 1 and 2)
Table A-10. VME-MXI-2 Hardware Default Settings
Hardware Component
A16 base address (U20)
VME-MXI-2 intermodule
signaling (W2)
MXIbus termination
(U21 Switches 3 and 4)
Configuration EEPROM
(U21 Switches 1 and 2)
DRAM SIMMs installed
SIMM size configuration (S2)
A-6
Default Setting
Ignored; effective only when
S7 is set to IN
Inverted
Receive CLK10 from MXIbus
Automatic MXIbus termination:
Switch 3 set to OFF; Switch 4
ignored
User-modifiable; factory
settings protected: both switches
set to OFF
Default Setting
Hex C040
No user-defined pin selected
Automatic MXIbus termination:
Switch 3 OFF; Switch 4 ignored
User-modifiable; factory
settings protected: both switches
OFF
Per customer order
OFF if SIMMS are 4 M × 32
or larger; ON if smaller than
4 M × 32
ni.com