Pioneer WYT Inverter Series Installation & User Manual page 33

Outdoor Unit Installation Instructions
Power/Signal Electrical Wiring to the Outdoor Unit
On the outdoor unit, the wiring diagram is located in the inner side of the handle cover.
The outside unit's terminal block is protected
by an electrical wiring cover on the side of
the unit. A comprehensive wiring diagram is
printed on the inside of the wiring cover.
1. Unscrew and remove the handle on the
right side plate of the outdoor unit.
2. Wire the system using the appropriate
gauge wire found on page 29/32 and the
wiring diagram found on the handle
cover. See page 43 for more details.
3. Fasten the power connection wires into
place using the supplied wire clamps.
4. Check the wiring against the diagram to
ensure it is wired correctly. A proper
ground must be established.
5. Re-screw and reinstall the cover handle.
Cover
Outdoor Unit Wiring Diagram
is located on the inside of the
wire cover on the outdoor unit.
Outdoor Handle Cover
7
Wiring Diagram
Page 33
 