How To Load Copy Paper In The Multi-Stack Bypass (Pc880) - Canon PC880 Operator's Manual

How to Load Copy Paper in the Multi-stack Bypass (PC880)

Use the multi-stack bypass when you want to copy on special copy stock, such as transparencies, labels or
heavy paper. You can place up to 50 sheets of 80 g/m
multi-stack bypass to be automatically fed into the copier.
1
Open the multi-stack bypass.
...............................
2
Adjust the slide guides to fit the size of the copy stock.
REQUEST:
If the slide guides are not adjusted correctly for the paper size, the
quality of your copy images may be adversely affected.
...............................
3
Load the copy stock face up into the multi-stack bypass.
NOTICE:
Insert the copy stock into the copier as far as it will go.
If the copy paper is curled, uncurl it before placing it in the cassette.
Failure to do so will cause paper creases and a paper jam.
52 to 128 g/m
Make sure that the height of the paper is not greater than the limit mark
( ) on the inside of the slide guides.
MEMO:
Some types of copy stock may not feed properly into the multi-stack
bypass. For high-quality copies, we recommended using paper and
transparencies recommended by Canon. (See p. 19.)
...............................
4
Fold up the multi-stack bypass as shown in the illustration.
...............................
2 copy paper is acceptable.
copy stock (a stack approximately 5 mm high) in the
2
INSTALLING THE COPIER
Load paper up to here
25