If Copies Are Completely Blank; If Your Copier Still Fails To Operate As Usual - Canon PC880 Operator's Manual

If Copies Are Completely Blank

(Copies Cannot Be Made).....
Check the Copy quantity/Copy ratio display.
Is and a number flashing alternately?
Q If so, there may be a malfunction with your copier. (See
p. 50.)
Is the copy exposure adjusted
correctly?
Q If not, adjust the copy exposure. (See
p. 33.)
Check the paper cassette.
Is the paper cassette inserted completely into
the main unit?
Q If not, insert the paper cassette as far as it will go.
(See p. 20.)
If the paper cassette cannot be completely inserted
into the copier, check the following:
Was the copier's power switch accidentally
turned OFF during copying?
Q If so, carry out the following procedure.
1. Turn the power switch ON.
2. Press the Start ( ) key.
3. When flashes and
quantity/Copy ratio display.
4. Insert the paper cassette as far as it will go.
5. Then press the Start ( ) key.
Condensation
If the copier is brought from the cold outdoors into a warm room, or if the room is rapidly heated,
condensation may form inside the copier. This can adversely affect the quality of your copy images.
When the copier is exposed to such conditions, allow at least two hours for the copier to adjust to room
temperature before attempting to use it.
If Your Copier Still Fails to Operate as
Usual
If, after performing the above steps, the copier still does not operate normally or copy quality is poor, turn the
power OFF, unplug the copier, and call your Service representative.
54
lights in the Copy
Check the control panel.
Is the Paper Supply (
and lit in the Copy quantity/Copy ratio
display? (PC880)
Is lit in the Copy quantity/Copy ratio
display? (PC860)
Q Load copy paper. (See p. 47.)
If flashes
Q Remove any jammed copy paper. (See p. 48.)
Is the cartridge installed in the copier?
Q If not, install the cartridge. (See p. 44.)
Is the sealing tape removed from the
cartridge?
Q If not, remove the sealing tape from the
cartridge. (See p. 45.)
Is there an original on the
platen glass?
Q If not, place the original to be
copied on the platen glass.
) indicator flashing