Basic Operations On Control Panel - Sanyo MCO-19AIC(UV) Instruction Manual

BASIC OPERATIONS ON CONTROL PANEL

The following operation are possible through control panel:
1. Setting the temperature
2. Setting the CO
2
3. Setting the key lock
4. Setting alarms
temperature (page 24) can be set.
5. Setting UV parameters
MCO-19AIC(UV) or when the Incubator is equipped with the optional MCO-19UVS (page 26).
6. Setting other parameters
LCD display and baud rate (page 32) can be set.
7. Displaying the operation log and transferring data
displayed (page 33) and operation data can be transferred to a PC (page 34).
8. H O decontamination
2 2
performed when the optional H
9. Automatic CO
2
CO Cylinder Changeover System (MCO-21GC) is installed (page 57).
2
10. Setting the CO
optional Automatic CO
19
The chamber temperature can be set (page 20).
density The chamber CO
Changing the temperature and CO
The temperature alarm, CO
ON/OFF parameters and the ON period of the UV lamp can be set for the
The initial settings of the date, time, and log cycle (page 30), and the
H O decontamination of the chamber and internal attachments can be
2 2
O Generator (MCO-HP) is installed (page 40).
2 2
cylinder changeover
standard gas density
2
Standard Gas Calibration Kit (MCO-SG) is installed. (page 59)
2
density can be set (page 20).
2
density can be disabled (page 21).
2
density alarm (page 25), and upper limit alarm
2
A graph of past operation data can be
The cylinder can be switched when the optional automatic
The CO standard gas density can be set when the
2
110