Table of Contents
Advertisement
INCUBATOR COMPONENTS
Control panel and keypad
4
5
6
7
1. Digital temperature indicator (TEMPERATURE
temperature. In the setting mode, it shows the set value of the chamber temperature. If the self
diagnostic function detects any abnormality, an error code will be displayed.
2. Heater lamp (HEAT): This lamp lights when the heater is energized.
3. UV indicator (UV):
recommends the replacement of UV lamp. See page 23 for the details.
4. Door lamp (DOOR): This lamp lights when the outer door is open.
5. Water level alarm lamp (RH PAN): This lamp flashes when the water in the humidifying pan is less
than approximately 0.8 liter.
6. Upper limit regulator: This regulator is used to set the upper temperature limit.
7. Over heat lamp (OVER HEAT): This lamp lights when the chamber temperature reaches the upper
limit set value.
8. CO
inject lamp (INJECT): This lamp lights when CO
2
9. Digital CO
density indicator (CO
2
chamber. In the setting mode, it indicates the set value of the CO
supply line is displayed when CO
page 25 for details.
10. O
inject lamp (INJECT): This lamp lights when N
2
11. Digital O
density indicator (O
2
chamber. In the setting mode, it indicates the set value of the CO
supply line is displayed when N
See page 25 for details.
13
3
2
This lamp lights when the UV lamp is ON.
%): Normally, this indicator shows the CO
2
gas cylinder becomes empty (only when MCO-5GC is installed). See
2
%): Normally, this indicator shows the O
2
or O
gas cylinder becomes empty (only when MCO-5GC is installed).
2
2
1
8
9
o
C): Normally, this indicator shows the chamber
gas is being injected.
2
2
or O
gas is being injected.
2
2
2
69
10
11
The blink of this indicator
concentration in the
2
concentration. The empty gas
concentration in the
2
concentration. The empty gas
Hide quick links:
Advertisement
Table of Contents
