Replacing Oil Filter And Oil; Removing The Oil Filters - Haskel Q-Drive QGD Series Installation, Operation And Maintenance Manual

12. Go to the Service page and tap Reset Count to restart the count at zero.

Replacing Oil Filter and Oil

The lubricating oil capacity is 30 litres (8 gallons). Replacement lubricating oil: 20 litres (5.2 gallons),
Syn-Gear EP150. Replace the oil filters each time you replace the oil.
Tools:

31 litre (8.2 gallons) container in total.
Container for approximately 1 litre (34 oz.)
o
Container for approximately 30 litres (8 gallons)
o

Strap wrench

12 mm hoses (2)

Hand pump

Removing the Oil Filters

1. Place the small container under the oil filters to catch any drips.
2. Remove the two 1/8 in breather plugs on the top of the motor end caps.
3. Close the drain valve.
4. Remove the plug.
5. Place the large container under the drain valve or attach a hose from the valve to the container.
Q-Drive Installation, Operation, and Maintenance Manual
Oil Pump Assembly in the Production unit
41 of 59