Site Preparation And Inspection; Installation And Setup - Haskel Q-Drive QGD Series Installation, Operation And Maintenance Manual

Q-Drive Installation, Operation, and Maintenance Manual
Ambient Temperature
Ambient Humidity
Storage/Shipping Environment
Ambient Temperature

Site Preparation and Inspection

Before delivery, plan the site for the system to avoid problems and expense of delays.

Choose an orientation that maintains alignment with machinery, power, and lines.

Allow a minimum of 2 ft (0.6 m) of clearance space on all sides and 4 ft (1.2 m) on front side of
the system.

Allow a minimum of 3 ft(0.9 m) of clearance space above the system (above the hoods).

Allow space for a catch tray and for access to plugs and to remove the system.

Plan the location and depth of the anchor bolts.

Prepare the electrical requirements listed in the "Specifications" table.
At delivery, inspect the exterior packaging for any damage or any signs of tampering such
as broken security seals. As you unpack the system, look for unusual dents or punctures.
Use the following procedure if you find damage.
1. Note the damage or loss with the exact exception on the Proof of Delivery.
2. Take photographs of the damage to external packaging, evidence of tampering, or broken
security seals. Keep all damaged product and packaging for a possible inspection.
3. Go to the Field Evaluation Report
report and following information to the Haskel regional sales office:

Photographs and a description of the damage.

Estimate of damage or loss.

Written Proof of Delivery with the noted exceptions.
Checklist
Surface is clean, dry, and level.
Space around and above the system is sufficient.
Location of holes for anchor bolts is correct.
No shipping damage.

Installation and Setup

CAUTION: Qualified electrical personnel must perform installation and maintenance.
32—131 °F (0—55 °C)
0-95%
-13—158 °F (-25—70 °C)
and fill out the report within 14 days of delivery. Send the
12 of 59