Haskel Q-Drive QGD Series Installation, Operation And Maintenance Manual page 39

14. Insert screw from under panel so that end is visible on top side of panel. Turn screw into bolt
until it is supporting adapter piece as shown below.
NOTE: One bolt will be shorter than the other due to heat exchanger interference
15. Inspect Adapter Piece is aligned so that assembly maintains concentricity.
16. Tighten bolts to 60 ft-lbs using a torque wrench so that adapter plate is fully installed.
Q-Drive Installation, Operation, and Maintenance Manual
Reference Image (Prototype Unit)
Reference Image (Prototype Unit)
33 of 59