Ordering Replacement Parts - Haskel Q-Drive QGD Series Installation, Operation And Maintenance Manual

When you exceed these limits, an alarm reminds you. The alarms create a maintenance record.
Maintain the system to maintain the warranty. Replace parts according to the following schedule.
After you complete the service, log into the system using a Service account and reset the values to
zero.

Ordering Replacement Parts

A good practice is to stock replacement parts to avoid interruption of production. When ordering,
specify the serial number of the system and the item number of the part.
Item
88338
88226
88224
88221
88321
88322
88323
88289
88289
88450
88449
88448
88447
WARNING: Do not modify the equipment or replace a part with a non-factory part.
Modifying the equipment may cause unpredictable operation which may result in
injury to the operator. Modifying this equipment avoids the warranty.
Q-Drive Installation, Operation, and Maintenance Manual
Replacing Part
Tie Rods
Gas Barrels
Check Valves
Gas Section Seals
Oil Filter
Oil
Part
Tie Rods
150mm Gas Barrel
90mm Gas Barrel
63mm Gas Barrel
Seal Kit for 150 mm Piston Assembly
Seal Kit for 90 mm Piston Assembly
Seal Kit for 63 mm Piston Assembly
Seal Kit for Check valve for inlet
Seal Kit for Check valve for outlet
Servo Actuator Repair Kit
Seal Kit for 150 mm Gas Section (includes
Piston As. Seal Kit)
Seal Kit for 90 mm Gas Section (includes Piston
As. Seal Kit)
Seal Kit for 63 mm Gas Section (includes Piston
As. Seal Kit)
Frequency
Every 3 years.
Every 7 years
After 2,000,000 cycles
After 1000 hours
After 2000 hours or 1 year
After 2000 hours
37 of 59